E-Flite 30-Amp Pro Switch-Mode BEC Brushless ESC (V2)

This is the E-flite 30-Amp Pro V2 Switch-mode BEC Brushless ESC. This is a
high-quality sensorless brushless electronic speed control with an integrated
switch-mode BEC that is very lightweight and efficient. It can operate without
the need for a separate receiver battery to power your servos and receivers,
saving you weight and complication. This ESC offers up to 30 amps of continuous current with proper airflow and a peak of 35A. It drives up to 7 analog or 6 digital standard-size servos with the BEC. This brushless ESC includes programmable motor braking, soft start for helis and planes, timing, throttle input range and low-voltage cutoff. It also features auto motor shutdown in case of lost signal or interference. The safe power-arm mode prevents accidental starts.

Features

• Up to 30 amps continuous current with proper air flow and 35 amps burst
  current (15 seconds)
  
• 3.5A continuous current, 5V Switch-Mode BEC Circuit
  
• Stronger BEC for support of most 3-axis stabilization systems
  
• Drive up to 7 analog or 6 digital standard-size servos with the BEC
  
• 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
  
• Programmable motor braking
  
• Safe power-arm mode prevents accidental starts
  
• Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V),
  4-cell Li-Po (12V) or 74% of battery starting voltage
  
• Programmable throttle input range (1.1ms-1.9ms or 1.2ms-1.8ms)
  
• Programmable soft start for helis and airplanes
  
• Auto motor shut down if signal is lost or there is interference
  
• Programmable timing – 5 user-selectable ranges for use with a large variety of
  brushless motors
  
• Pre-wired connectors – E-flite EC3 connector on battery input and 3.5mm gold
  bullet connectors on motor output leads
  

Specifications:
Continuous Maximum Current: 30A
Input Voltage: 3-4S Li-Po or
9-12 Ni-MH/Ni-Cd

Input Connector Types: 16 AWG leads with E-flite EC3
Connector

Output Connector Types: 16 AWG leads with 3.5mm Gold Bullet
Connectors

Momentary Peak Current: 35A (15
sec)

Length: 51.0mm (2.00 in)
Width: 28.0mm (1.10
in)

Height: 8.70mm (0.35 in)
Weight: 31.0 g (1.10
oz)

Wire Gauge: 16 AWG